Retaining walls hold back soil on sloping gardens, driveways, basements and building sites. Because they resist constant pressure from the ground behind them, they need a properly designed footing, the right concrete and good drainage. This guide covers the essentials of retaining wall concrete for UK projects.
Do You Need an Engineer?
Low garden walls holding back a small amount of soil can sometimes follow standard details. Higher walls, walls near buildings, roads or boundaries, and any wall supporting a driveway or structure should be designed by a structural engineer. Failure of a retaining wall can be dangerous and expensive, so check with Building Control if you are unsure.
Types of Concrete Retaining Wall
- Mass concrete walls: rely on their weight, suited to lower heights.
- Reinforced concrete cantilever walls: an L- or T-shaped wall and footing with steel reinforcement, used for taller walls.
- Block walls with concrete footings: hollow blocks filled with concrete and reinforced with steel bars.
The Footing
The footing spreads the load into the ground and stops the wall from sliding or overturning. It is typically wider than the wall and dug down to firm, undisturbed ground. Reinforcement is often tied into the footing with starter bars that continue up into the wall. See our guide to steel mesh vs rebar.
Which Concrete Grade?
Retaining walls and footings are structural elements and commonly use mixes around C25–C35, depending on the design and exposure to soil and moisture. Your engineer’s specification takes priority. Our guide to concrete grades explains the differences.
Drainage Is Essential
Water building up behind a wall adds a lot of pressure. Good drainage usually includes:
- Free-draining gravel backfill behind the wall
- A perforated drainage pipe at the base, leading water away
- Weep holes through the wall where specified
- A waterproof coating or membrane on the soil side, where required
Pouring Tips
- Strong formwork: wet concrete in a tall wall pushes hard on the shuttering, so brace it well.
- Pour in layers: place and compact concrete in layers to avoid voids.
- Vibrate properly: use a poker vibrator to remove trapped air, especially around reinforcement.
- Use a pump for access: walls at the back of a garden or below ground are much easier with a line pump.
- Cure and protect: keep the concrete damp and protected from frost while it gains strength.
Concrete Supply for Retaining Walls in London
METRO Readymix delivers ready mix concrete and volumetric concrete for footings and retaining walls across London, with pump hire for difficult access. Call 020 8129 0605 or get a free quote.
Need Concrete Delivered in London?
Ready mix, volumetric concrete and pump hire. Tell us your postcode, volume and date for a fast, free quote.